What counts as an installation
Installation includes sinks, faucets, toilets, showers and tubs, dishwashers, washing machines, ice makers, outdoor spigots and new shutoff valves. It also includes the hidden work of rough-in plumbing before walls close during a remodel.
Each fixture has supply, drain and vent requirements. A fixture that looks simple may need a new vent or a wider drain, so we check what is behind the wall before ordering. Appliance manuals set the guidelines for supply and drain connections, and the Florida Building Code, Plumbing governs fixtures and venting.
What we confirm before installing
- Supply and shutoffA working shutoff valve makes later service easier.
- Drain size and slopeA fixture needs the correct drain size and fall to drain properly.
- VentingA vent lets air in so traps do not siphon.
- Water pressureToo high a pressure strains new fixtures.
- Local codeThe Florida Building Code, Plumbing, 8th Edition (2023) governs the work.
Common installs and prep
| Install | Prep needed | Notes. |
|---|---|---|
| Toilet swap | Shutoff and floor flange check | See toilet repair and installation. |
| Faucet swap | Shutoffs and sink cutout fit | See faucet repair. |
| Garbage disposal | Power, drain and dishwasher hose | See garbage disposal service. |
| Dishwasher or washer | Supply, drain and power | Check the drain height. |
| New bathroom | Rough-in, venting and permit review | Plan before walls close. |
How an install visit runs
Check the site
We confirm shutoffs, drains and venting.
Rough in if needed
We run new lines before walls close.
Set the fixture
We install, seal and connect to supply and drain.
Test
We pressure test and run water to check for leaks.
Remodels and permits
A remodel that moves walls or adds a bathroom will usually involve a permit. Permit rules vary, so check with the Palm Beach Gardens Building Division at 561-799-4210, which accepts permits through an online system.
We coordinate rough-in timing with your contractor so inspectors see open walls when they should. If we do the plumbing, we describe what each inspection looks at.
Planning a remodel?
Call and we will talk through the plumbing before walls close.
Installing for Florida homes
Slab homes put drains in concrete, so moving a fixture can mean cutting the floor. We plan fixture locations around existing drains where possible. In two-story homes, venting and water hammer are additional concerns.
Outdoor spigots and irrigation tie-ins need backflow protection. We install the correct device where required and explain why it is there.
What affects installation cost
Scope and access decide the number.
Appliance hookups we handle
Dishwashers need a hot supply, a drain with a high loop and power. Washing machines need two supply valves and a standpipe with an air gap. Ice makers need a small supply line with a shutoff. Each has quirks, such as the correct drain height, which we confirm before the appliance goes in.
Gas dryers and ranges need a flexible connector, a shutoff and a leak check. If the appliance is new, ask the seller about connector kits so you do not make a second trip.
Getting ready for the visit
Clear the space around the sink, closet or laundry area. Tell us about any past leaks or slow drains in that spot. Have the fixture or appliance on site, with its manual, so we can check the rough-in dimensions before we start.
Take a photo of the area under the sink or behind the washer before the visit. It helps us bring the right fittings and avoids a second trip for a missing part.
Questions we hear most
Yes, in most cases. We confirm the fixture suits your supply and drain before starting.
Yes. We coordinate with your contractor around the schedule.
Permit rules vary, so ask the building division. We explain what we know about your scope.
Installs are scheduled work. For a leak or backup, call the 24/7 line at (561) 448-8545.
Yes. Individual shutoffs are a worthwhile upgrade.
We do, with a high loop or air gap as required.
